Rank: Veteran
Groups: Registered, Veteran
Joined: 1/03/2005(UTC)
Posts: 1,991
Was thanked: 2 time(s) in 2 post(s)
|
Went to garage sale today, picked up 2 hammers I am not sure what they are for.
Both are like small tack hammer , one has a pointy head and a head with a flat face, the is a chisel head with a rounded face.
I assume these profiles are there for a reason. Can anyone tell me what?
I believe the pointy head and the chisel head are obvious but not flat face and rounded face?
thanks
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 21/12/2018(UTC) Posts: 100 ![Australia]( "Australia") Location: SA Thanks: 26 times
Was thanked: 14 time(s) in 14 post(s)
|
I am a self-taught and really bad panel beater but IIUC they go behind the piece of metal you are trying to shape. So put the curved face behind a curved piece of metal, then hit it on the other side to shape it. It transfers the force to the hit-point rather than spreading it over the whole piece of metal.
Or this could be completely wrong!:)
|
|
|
|
|
|
Rank: Veteran
Groups: Registered, Veteran
Joined: 1/03/2005(UTC)
Posts: 1,991
Was thanked: 2 time(s) in 2 post(s)
|
Thanks 202.
I thought you used an anvil to do that- a shaped piece steel block that you hammered against.
But it appears no one else has ideas..
regards,
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
