Welcome Guest! To enable all features please Login or Register.

Notification

Icon
Error

Login


Take the time to read our Privacy Policy.

Shar Offline
#1 Posted : Thursday, 18 March 2021 7:32:08 PM(UTC)
Shar

Rank: Newbie

Reputation:

Groups: Registered
Joined: 18/03/2021(UTC)
Posts: 1
Australia
Location: Toowoomba

Hey guys just have a question about putting my nine inch into my HQ toner. I have never done a conversation and am quite new to this. (Chippy by trade)

I currently have a stock 9 inch. I understand that my 9 inch is off centre. What is the best way to line this back up with The Holden engines trans. Can you simply attach off centre and drill out for Holden stud pattern? I’m assuming not. What would be the best process?

I aslo have a set of Ford disk breaks, can these be converted to Holden brake system easy enough?
HK1837 Offline
#2 Posted : Friday, 19 March 2021 7:11:28 AM(UTC)
HK1837

Rank: Veteran

Reputation:

Groups: Moderator, Registered, Veteran
Joined: 1/03/2005(UTC)
Posts: 14,569

Thanks: 1 times
Was thanked: 480 time(s) in 458 post(s)
Sell the housing and axles, keep the centre. Get a diff shop to make you up a new housing and billet axles to suit the centre that will bolt straight into your HQ including using the HQ brakes. You’ll need to get a tailshaft made to suit too. This way you’ll also use proper 1-tonner rear bearings.

In the past you’d modify the housing, redrill axles, adapt the Ford brakes to the Holden setup etc. Simply not worth it today.
_______________________________________________________
If we all had the same (good) taste, who would buy all the Fords?
Dr Terry Offline
#3 Posted : Friday, 19 March 2021 2:41:23 PM(UTC)
Dr Terry

Rank: Veteran

Reputation:

Groups: Moderator, Registered
Joined: 1/03/2005(UTC)
Posts: 6,015

Thanks: 1 times
Was thanked: 197 time(s) in 180 post(s)
Being a One-Tonner having the tailshaft off-centre won't be a problem. I assume this rear axle is from an XB or XC, because it has disc brakes.

The cheap conversion would be to weld spring pads to it & simply run Ford pattern wheels. Problem is the Ford rear brakes are crap & the rear wheel bearing aren't much better.

As HK1837 has said, keep the centre & the middle part of the housing & run the Holden axles & outer axle tubes. The Holden axles have the same spline & fit straight into the Ford 9-inch centre. This means you have standard Holden brakes & GM stud pattern wheels. The only welding required is to the axle tubes. This also places the tail-shaft closer to centre.

Dr Terry

Edited by user Friday, 19 March 2021 3:44:28 PM(UTC)  | Reason: Not specified

If at first you don't succeed, just call it Version 1.0
Users browsing this topic
Guest
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.

Powered by YAF | YAF © 2003-2024, Yet Another Forum.NET
This page was generated in 0.064 seconds.