Rank: Guest
Groups: Guests
Joined: 2/09/2015(UTC)
Posts: 43,977
Was thanked: 5 time(s) in 5 post(s)
|
hi, just wondering what is the best way to go about putting a 308 into a fj holden ute 4 speed gearbox,whats the best diff brakes front end, everything. what needs to be cut/welded to make it fit. thanks
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 19/05/2006(UTC)
Posts: 203
|
the simplest way (not nessaseraly the best) is to get the kit form CRS |
|
|
|
|
|
|
Rank: Guest
Groups: Guests
Joined: 2/09/2015(UTC)
Posts: 43,977
Was thanked: 5 time(s) in 5 post(s)
|
HR front end and diff, add two leaves to the rear leaf packs or tramp rods if your making serious power.
If your doing a complete restoration you may want to make the tunnel higher and wider.
Also you'll need a bigger radiator with thermos.
Cheer
|
|
|
|
|
|
Rank: Veteran
Groups: Moderator, Registered, Veteran
Joined: 1/03/2005(UTC)
Posts: 14,852
Thanks: 1 times
Was thanked: 539 time(s) in 514 post(s)
|
In NSW stay below 300 cubes IIRC. |
_______________________________________________________
If we all had the same (good) taste, who would buy all the Fords? |
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 29/01/2006(UTC)
Posts: 220
|
FIRSTLY, run this by your states RTA. And get the basic guidlines as to what is the Max allowed cid to body(factory) weight. you will be restricted to as how far you can go.
Secondly, look for a acredited engineer that is willing to see the project throu |
Never stop being inspired,
You may never realize your full potential. |
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
