Rank: Member
Groups: Registered
Joined: 6/01/2007(UTC)
Posts: 282
|
Hi all,for all of you that have done an EFI conversion in their vehicles...which a/market vehicle speed sensor did you use and approx cost?
I have the T700 tranny in my HJ coupe which i currently use a switch for the TCC lock up and would like the ECU to take over.
Kalmaker have one @$115.00...What others are there?
Cheers ...mario
|
|
|
|
|
|
Rank: Veteran
Groups: Moderator, Registered, Veteran
Joined: 1/03/2005(UTC)
Posts: 14,898
Thanks: 1 times
Was thanked: 558 time(s) in 533 post(s)
|
Mario
Use the Kalmaker one. In a standard VN/VP the speed sensoe screws in the side of the box and puts out 10 pulses per rev for the speedo. Inside the VN/P speedo the electronics converts the signal to 2 pulses per rev for the ECU and cruise control. |
_______________________________________________________
If we all had the same (good) taste, who would buy all the Fords? |
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 6/01/2007(UTC)
Posts: 282
|
Thanks Byron,
I have all that you mentioned and i am using the AT29c256 chip so i can stack the files to run my LPG once i have it hooked up.
I am trying out different cals at the moment to gauge the differences on my EFI project that i made up.
Surpri
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
