Rank: Member
Groups: Registered
Joined: 11/10/2012(UTC)
Posts: 247
|
So im in need of a saginaw into hk. Ive come accross a saginaw into htg with 253 308. Mines a 307 chev. Other then the bellhousing flywheel and shifter mount being different, what else is different. If i have the hk x member for saginaw shifter to mount to can i use the shift rods throwout fork slave cylinder etc.
|
|
|
|
|
|
Rank: Veteran
Groups: Moderator, Registered, Veteran
Joined: 1/03/2005(UTC)
Posts: 14,717
Thanks: 1 times
Was thanked: 512 time(s) in 488 post(s)
|
Fork will be different as HT-HG 253/308 use a rat-trap, so no slave cylinder on these either. From memory the shift rods are different too. Box should be the same, only different boxes were the commercial 6cyl boxes with 2.85:1 1st and the HT-HG 350 boxes were stronger (upgraded bearings). |
_______________________________________________________
If we all had the same (good) taste, who would buy all the Fords? |
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 16/04/2014(UTC) Posts: 768  Location: Victoria Thanks: 1 times
Was thanked: 49 time(s) in 47 post(s)
|
The shift rods are indeed different between HK and HT/G. They are different lengths and have different bend locations.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
