Rank: Member
Groups: Registered
Joined: 21/04/2017(UTC) Posts: 293 ![Australia]( "Australia") Location: Tolmie Thanks: 2 times
Was thanked: 24 time(s) in 24 post(s)
|
I've got hold of a better front bumper for the Hk Brougham and before I put it on i'm just wondering if there's a "correct" position for the bumperettes.
I'm happy with where mine are at the moment, about 2 inch's on the inside of the bumper bolts. they're out past the tip of the bumper, which I presume is where their supposed to be.
Is there an actual instillation measurement?
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 15/10/2010(UTC)
Posts: 35
Thanks: 2 times
Was thanked: 5 time(s) in 5 post(s)
|
Nasco sheet shows front ones 1300 mm each side of centreline of car, rears 1450 mm (assuming bumperettes = over riders) Edited by user Friday, 18 January 2019 8:46:02 PM(UTC)
| Reason: Not specified
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 21/04/2017(UTC) Posts: 293 ![Australia]( "Australia") Location: Tolmie Thanks: 2 times
Was thanked: 24 time(s) in 24 post(s)
|
Thanks WAHK80737 I couldn't remember the name of the bloody things. Bumperettes are the short rear bumpers for the utes and vans. Over riders are what I meant to say.
Did you read those measurements correctly? 1300mm each side, bloody wide HK. If it's 13 inch's each side that's ok as mine are sitting at 12 inch at the moment.
Thanks.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 15/10/2010(UTC)
Posts: 35
Thanks: 2 times
Was thanked: 5 time(s) in 5 post(s)
|
Yes, didn’t think too much about what I was posting! ..., more likely, 13.00 inches and 14.5 inches
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
