Fastlane
»
Holden Forums
»
Holden General Discussion
»
Help for Mechanically Hopeless Please
Rank: Member
Groups: Registered
Joined: 16/09/2009(UTC)
Posts: 358
Was thanked: 2 time(s) in 2 post(s)
|
Team I pulled apart my heater so I can give it a freshen up. I want to get the bits rezinced. Im a bit stuck. Can anyone tell me how these 2 bits go together. I can't seem to prize them off easily, and I don't want to use too much force in case I brake them. Help please?? The fan from the fan motor shaft - I got the metal clip off, now can't get the fan off the shaft....  And the crank on the shaft directing air flap thang...  Thanks in advance. Cheers Jeremy The G will roll again.... |
The G will roll again.... eventually |
|
|
|
|
|
Rank: Veteran
Groups: Registered, Veteran
Joined: 1/03/2005(UTC)
Posts: 1,991
Was thanked: 2 time(s) in 2 post(s)
|
Jeremy I think you have to remove the metal clip thing, it looks like you stretch it, and use a puller. the nylon stuff looks like it clamps as the metal strip is clamped down.
I do suspect that the nylon will disintegrate very easily so you might be well to leave it alone and just paint the lot. the same with the lever, these are usually diecast rubbish metal that has no strength and cannot be repaired if it does break.
Otherwise find a damaged/useless fan and experiment on that.
|
|
|
|
|
|
Rank: Veteran
Groups: Moderator, Registered, Veteran
Joined: 28/03/2008(UTC)
Posts: 1,903
|
i agree,john,fixem,cleanem,refitem.trouble you dont need.
Jim in Adelaide...Hindsight is bad vision! |
Jim in Adelaide.. |
|
|
|
|
|
Fastlane
»
Holden Forums
»
Holden General Discussion
»
Help for Mechanically Hopeless Please
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
