Rank: Member
Groups: Registered
Joined: 10/09/2010(UTC)
Posts: 2
|
Just need some measurements for welding in some consul mounts in my HQ One Tonner . Any ideas Thanks Matt
|
|
|
|
|
|
Rank: Veteran
Groups: Moderator, Registered, Veteran
Joined: 1/03/2005(UTC)
Posts: 14,728
Thanks: 1 times
Was thanked: 513 time(s) in 489 post(s)
|
Matt
Find a car and measure. It will make it heaps easier for you.
_______________________________________________________
If we all had the same (good) taste, who would buy all the Fords? |
_______________________________________________________
If we all had the same (good) taste, who would buy all the Fords? |
|
|
|
|
|
Rank: Veteran
Groups: Moderator, Registered, Veteran
Joined: 28/03/2008(UTC)
Posts: 1,903
|
Matt,as above or put everything in its place including gear shifter/tbar and sit in comfortably and go from there,if its a one tonner that"ll be ok,I wouldnt do this on a monaro,no offense.I did that in my HQ panelvan with a hz console.
Jim in Adelaide.. |
Jim in Adelaide.. |
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 10/09/2010(UTC)
Posts: 2
|
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 7/03/2005(UTC)
Posts: 397
Was thanked: 1 time(s) in 1 post(s)
|
Hi Matt,
If it is an auto - only mark the holes for the 3 mounting screws once the console is in place and the orange t-bar indicator is inline with whatever position the shifter is in. Otherwise it will be out of line and p$*% you off.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
