Fastlane
»
Holden Forums
»
Holden General Discussion
»
electronic ignition to 253 red and 350 holley
Rank: Guest
Groups: Guests
Joined: 2/09/2015(UTC)
Posts: 43,977
Was thanked: 5 time(s) in 5 post(s)
|
Hi,have gotten my hands on a electronic distributor from a vh 253 and i want to put it in my hx one tonner,is it just a staight swap with the original distributor or is there more to it than that,Also would a 350 holley from a ford 302 be ok to bolt on or will it need to be re jetted to suit a 253,thank for any advice.
|
|
|
|
|
|
Rank: Guest
Groups: Guests
Joined: 2/09/2015(UTC)
Posts: 43,977
Was thanked: 5 time(s) in 5 post(s)
|
I would get the 2bbl stromberg re kitted or re jetted, I find holleys drink more fuel , the dizzy is a good move and will keep your plugs cleaner too.
|
|
|
|
|
|
Rank: Guest
Groups: Guests
Joined: 2/09/2015(UTC)
Posts: 43,977
Was thanked: 5 time(s) in 5 post(s)
|
Make sure you get a 12V coil, and you need to run 12V to the coil, rather than the 9V supply that it will have now. That is bypass the resistor wire in the wiring harness that goes from your ignition switch to the coil. Leave the cranking wire in place as
|
|
|
|
|
|
Fastlane
»
Holden Forums
»
Holden General Discussion
»
electronic ignition to 253 red and 350 holley
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
