Rank: Member
Groups: Registered
Joined: 11/08/2009(UTC)
Posts: 36
|
Hi can anyone tell me if a set of blue or black motor extractors will fit a red motor head 9 port if you modify mounting holes? thanks .
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 8/03/2009(UTC)
Posts: 45
|
First, are we talking E.F.I extractors only?
If so, youll find they they will foul on most single carbie manifolds and maybe some triple application manifolds depending on the length of the runners.
The E.F.I extractor primary pipes depart the head higher than carby extractors which point down after exiting the head.
|
|
|
|
|
|
Rank: Veteran
Groups: Moderator, Registered, Veteran
Joined: 1/03/2005(UTC)
Posts: 14,894
Thanks: 1 times
Was thanked: 554 time(s) in 529 post(s)
|
They go close port wise, but from memory the red outer port are slightly closer to the centre. Best check is a blue/black gasket up against a red head.
Then youll also most likely have problems as described by Casper.
_______________________________________________________
If we all had the same (good) taste, who would buy all the Fords? |
_______________________________________________________
If we all had the same (good) taste, who would buy all the Fords? |
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 3/01/2009(UTC)
Posts: 435
Was thanked: 1 time(s) in 1 post(s)
|
Different enough not to be worth doing. Use the correct extractor configuration for the job at hand. P.S. If the extractors that you are considering are factory from an EFI VK Commodore, they will not fit into an EH body. I mention this as I noticed the 064 in your forum log in. WB commercial extractors will fit. Utility8  Edited by user Friday, 11 September 2009 9:44:38 PM(UTC)
| Reason: Not specified |
utility8
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
