Fastlane
»
Holden Forums
»
Holden General Discussion
»
HQ '73 Inlet Manifold compatability (253)
Rank: Member
Groups: Registered
Joined: 5/05/2005(UTC)
Posts: 85
|
Hi there,
Just had the water temp sender bolt sleve strip in the manifold. Hopefully i can get a new thread in it.
Incase its wrecked what engine types (ie manifolds)will fit to a blue 253? In NZ there are no emmission worries that i know of.
cheers
Rock n Roll |
Rock n Roll |
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 28/04/2005(UTC)
Posts: 758
|
Hi K1W1,
They all strup ! Two uf mine huv strupped ! I jest tapped nuw thruds.
Seriously Kiwi - they do strip out. I think its the old alloy and high tensile bolts that do it. Just pick a slightly larger diameter thread and re-tap it. Use some aviat
|
|
|
|
|
|
Rank: Veteran
Groups: Moderator, Registered, Veteran
Joined: 1/03/2005(UTC)
Posts: 14,740
Thanks: 1 times
Was thanked: 516 time(s) in 492 post(s)
|
Any blue or black V8 manifold, assuming it's an original blue 253, not a blue painted red one. KC castings make a manifold called a 253308 that will fit also. I think you can buy it off this site through rare's also. |
_______________________________________________________
If we all had the same (good) taste, who would buy all the Fords? |
|
|
|
|
|
Fastlane
»
Holden Forums
»
Holden General Discussion
»
HQ '73 Inlet Manifold compatability (253)
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
