Rank: Guest
Groups: Guests
Joined: 2/09/2015(UTC)
Posts: 43,977
Was thanked: 5 time(s) in 5 post(s)
|
Howdy,
Does anyone know if a Tremec Commodore 5 speed will clear a bench seat in an HG ute....? Has anyone done this conversion - do you retain the original clutch set up or do you have to go hydraulic? I know a celica wont fit with the bench - any other ideas? Do any of the chev autos (350 etc) have an over-drive & would be compatable with a carburettored engine?
The Beige Hornet.
|
|
|
|
|
|
Rank: Veteran
Groups: Moderator, Registered, Veteran
Joined: 1/03/2005(UTC)
Posts: 14,898
Thanks: 1 times
Was thanked: 556 time(s) in 531 post(s)
|
A TH700R4 out of a VN or VP V8 will do the job. Plus you can shift it from a B&M cable shifter that can be mounted as far forward as the dash permits. There is a TH200R4 available in the USA that is the same length as a TH350.
_________________________ |
_______________________________________________________
If we all had the same (good) taste, who would buy all the Fords? |
|
|
|
|
|
Rank: Veteran
Groups: Moderator, Registered, Veteran
Joined: 2/03/2005(UTC)
Posts: 2,898
Was thanked: 2 time(s) in 2 post(s)
|
You may be better off looking at a ford T5 as they have a shorter input shaft than the V6 Commodore 5 speed which in turn would put the gear stick further forward. Dellow in Sydney know a fair bit about what t5's have what characteristics. www.dellowauto. |
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
