Rank: Member
Groups: Registered
Joined: 14/03/2005(UTC)
Posts: 190
|
Does anyone have a photo or diagram of a factory setup for Hq/Z central locking?
i cant get after market units to work properly and i want to know how holden did it from factory.
Anyne able to help?
Not the BLOODY Kingswood |
Not the BLOODY Kingswood |
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 29/06/2005(UTC)
Posts: 287
|
What's your problem with after market? I've fitted it to a HQ, and LH. All fine. Had to clean and re-grease the door lock mechanisms, and adjust the spring so that the solenoids could operate, but it is very possible and easy with some time and patienc
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 29/06/2005(UTC)
Posts: 287
|
Whats your problem with after market? Ive fitted it to a HQ, and LH. All fine. Had to clean and re-grease the door lock mechanisms, and adjust the spring so that the solenoids could operate, but it is very possible and easy with some time and patience.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 14/03/2005(UTC)
Posts: 190
|
Hi Jason.
I ajusted the springs and cleaned the locks but i cant get it right.The drivers side front and rear work ok but passenger side is a pain.They open the lock but when you go to open the door from the outside it makes a clunk and wont open.If you |
Not the BLOODY Kingswood |
|
|
|
|
|
Rank: Guest
Groups: Guests
Joined: 2/09/2015(UTC)
Posts: 43,977
Was thanked: 5 time(s) in 5 post(s)
|
Can't help you with the wiring diagram, but you should be able to use the aftermarket relay/controller and connect them to the factory Holden solenoids. Just bear in mind that the aftermarket solenoids have a "master" for the driver's door and the Holden
|
|
|
|
|
|
Rank: Guest
Groups: Guests
Joined: 2/09/2015(UTC)
Posts: 43,977
Was thanked: 5 time(s) in 5 post(s)
|
Cant help you with the wiring diagram, but you should be able to use the aftermarket relay/controller and connect them to the factory Holden solenoids. Just bear in mind that the aftermarket solenoids have a "master" for the drivers door and the Holden on
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 29/06/2005(UTC)
Posts: 287
|
GMH - Im in Bris, so cant help in person, then.
Ok, so it sounds as if the solenoid doesnt have enough "bite" on the rod to unlock. Does it lock fine? Unlock by hand, then trigger central locking to lock it, then try to open the door. All good? May
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 29/06/2005(UTC)
Posts: 287
|
GMH - I'm in Bris, so can't help in person, then.
Ok, so it sounds as if the solenoid doesn't have enough "bite" on the rod to unlock. Does it lock fine? Unlock by hand, then trigger central locking to lock it, then try to open the door. All good?
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
