Rank: Member
Groups: Registered
Joined: 31/03/2022(UTC) Posts: 14 ![Australia]( "Australia") Location: Perth Thanks: 1 times
|
Hi all,
Just after some help in identifying the 3 wire going to ignition coil on my Hr holden.
I have 3 wires, one red, one yellow and a black one that seems to have some sort of rough coating.
Any help would be appreciated.
|
|
|
|
|
|
Rank: Veteran
Groups: Moderator, Registered, Veteran
Joined: 1/03/2005(UTC)
Posts: 14,583
Thanks: 1 times
Was thanked: 483 time(s) in 461 post(s)
|
If its original wiring, common sense says red and yellow to the + side of the coil and black to the - side. BUt wait until a HR guru answers! |
_______________________________________________________
If we all had the same (good) taste, who would buy all the Fords? |
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 31/03/2022(UTC) Posts: 14 ![Australia]( "Australia") Location: Perth Thanks: 1 times
|
Thanks HK1837, all 3 have always gone to the + side of coil with the condenser coming off the -.
At the moment i have no voltage showing on the red and yellow when they are attached to the coil.
I believe one should be from "on" and one from "start" from ignition switch, just not sure which is which.
|
|
|
|
|
|
Rank: Veteran
Groups: Moderator, Registered, Veteran
Joined: 1/03/2005(UTC)
Posts: 14,583
Thanks: 1 times
Was thanked: 483 time(s) in 461 post(s)
|
Yes, one is a resistance wire for RUN and the other 12V for START. Not sure what the 3rd will be on the 12V terminal, |
_______________________________________________________
If we all had the same (good) taste, who would buy all the Fords? |
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
