Rank: Member
Groups: Registered
Joined: 5/05/2006(UTC) Posts: 92  ![Australia]( "Australia") Thanks: 1 times
Was thanked: 1 time(s) in 1 post(s)
|
Dear All,
Can anyone assist with advice as to why my headlights will not work on high beam.
It is a HZ with twin headlight front.
High beam was working, then stopped. Only low beam now work. When I click onto high beam, no lights at all.
Replaced stalk with a new one and no change.
If I hold lever back all lights work, but as soon as I let go, nothing.
Any advice welcome.
kind regards Dave
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 21/07/2014(UTC)
Posts: 75
|
I'd check if there is a high beam relay, and if so, check it or swap it for the low beam relay and test the lights again. HZ probably has relays for headlights but I can't say for sure. Worth checking though.
|
|
|
|
|
|
Rank: Veteran
Groups: Moderator, Registered, Veteran
Joined: 2/03/2005(UTC)
Posts: 3,135
Thanks: 1 times
Was thanked: 35 time(s) in 33 post(s)
|
If it's wired anything like the VB commodore that used the same stalk (minus the reverse light circuit through the blinker switch section) then the "flash" runs through a different fuse to the continuous high beam, so you can still get momentary power to the high beams by pulling back on the wand, but it won't change over to high beam. |
Cheers,
Mick
_______________________________________________________________
Judge a successful man not on how he treats his peers, but on how he treats those less fortunate. |
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 5/05/2006(UTC) Posts: 92 ![Australia]( "Australia") Thanks: 1 times
Was thanked: 1 time(s) in 1 post(s)
|
Thank you for your advice.
Will check out the relays.
Thanks again
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
