Rank: Guest
Groups: Guests
Joined: 2/09/2015(UTC)
Posts: 43,977
Was thanked: 5 time(s) in 5 post(s)
|
hey im wondering can i bore and stroke my 307chev to the same sizes as a 350chev.
and if this is too expensive would it be easier to buy a 350 short motor and bolt my stuff on.
does it all fit ? manifolds , timing gear ?
would the gear drive i have fit a 350 crank ??
any help would be good thanks.
|
|
|
|
|
|
Rank: Veteran
Groups: Moderator, Registered, Veteran
Joined: 1/03/2005(UTC)
Posts: 14,898
Thanks: 1 times
Was thanked: 558 time(s) in 533 post(s)
|
An aussie 307 (ie HK/HT) can normally be bored to 4". This gives you a 327 cube engine. If you use a 350 crank and 350 pistons you get 350 cubes. You could also use a 3.75" stroke crank (basically a 400 crank with mains ground to suit) and suitable piston |
_______________________________________________________
If we all had the same (good) taste, who would buy all the Fords? |
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
