Rank: Veteran
Groups: Registered, Veteran
Joined: 3/08/2007(UTC)
Posts: 1,902
|
hey guys, does anyoe know the dimensions to cut into the bonnet for a shaker on an XY?.
save me alot of time as its in the panel shop at the moment.
thanks in advance.
"bog and Flog" |
Old holdens brought on the spot, quick decision, cash paid. |
|
|
|
|
|
Rank: Veteran
Groups: Moderator, Registered, Veteran
Joined: 2/03/2005(UTC)
Posts: 2,898
Was thanked: 2 time(s) in 2 post(s)
|
here you go: http://www.fordforums.co...t=46111&highlight=shaker
If at first you don't succeed then skydiving is not for you. |
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 1/05/2005(UTC)
Posts: 58
|
The shaker hole starts 6 inches from the rear of the bonnet.
You can get a template for cutting the hole.
Are you doing GT Bonnet stripes?
--
It's good to honk in a Henry |
--
It's good to honk in a Henry |
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 10/07/2008(UTC)
Posts: 8
|
Hey there. You should buy the the Shaker bonnet hood template for cutting out the hole from www.fomoco.com.auPart number SHAKBHT-02 only cost's $35 so a lot less mucking around and it is easiy to use and is accurate. Good luck mate!!
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
