Rank: Member
Groups: Registered
Joined: 17/11/2006(UTC)
Posts: 69
|
Howdy,
I have recently acquired a vs calais and taking previous advice are going to swap the engine loom and all the wiring looms to get some creature comforts into my manual ute. However I would like to try and keep my ute as a munual. Have checked previous forums and have found much that has helped. So I have a couple of questions.
1. Can you swap an auto to a manual?
2. Do you need to do anything to the loom to accept a manual?
|
|
|
|
|
|
Rank: Veteran
Groups: Moderator, Registered, Veteran
Joined: 1/03/2005(UTC)
Posts: 14,897
Thanks: 1 times
Was thanked: 554 time(s) in 529 post(s)
|
VS manual and auto use different ECU and Memcal (at least in the earlier models), plus there is a fair bit of difference between VS through to VSIII. Im no expert on them but it sounds like a lot of work to me. Im pretty sure the auto and manual harnesses |
_______________________________________________________
If we all had the same (good) taste, who would buy all the Fords? |
|
|
|
|
|
Rank: Veteran
Groups: Moderator, Registered, Veteran
Joined: 2/03/2005(UTC)
Posts: 3,135
Thanks: 1 times
Was thanked: 35 time(s) in 33 post(s)
|
If your ute is also a VS, then the VS calais body harness swap into the ute is the best bet - entire body & dash harness (play with the wires to mate up the rear harness).
Retain your engine harness, and its plug-n-play into the Calais one.
Only 1 p |
Cheers,
Mick
_______________________________________________________________
Judge a successful man not on how he treats his peers, but on how he treats those less fortunate. |
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
