Rank: Member
Groups: Registered
Joined: 4/10/2008(UTC)
Posts: 77
|
Can anyone tell me what pushrod length they have used to get the rocker moving onto the center of the valve tops.
I have AFR aluminium heads and Yella Terra roller rockers.
Have ground an old pusrod down and ground the head round to get what I think is the correct length which is 193 mm or 7 5/8 long.this is about 4 mm shorter than the standard pushrod length.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 28/12/2008(UTC)
Posts: 782
|
All depending on ur cam heads and block etc , its a bit hard to say, so check this out :http://www.carcraft.com/techarticles/116_0401_setting_pushrod_length/index.html
 < Gotta Luv It! |
 <b><font color="orange">< 4 SALE , SELLING .......SOLD!</b></font id="orange"> |
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 10/11/2006(UTC)
Posts: 543
Was thanked: 1 time(s) in 1 post(s)
|
all depends on a lot of things, the article above is a good explanation, basically at half lift you want the roller tip in the centre of the valve, lenght depends on cam base circle block deck height, head deck thickness.
pete.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 4/10/2008(UTC)
Posts: 77
|
Thanks.Made an adjustable push rod and measured it from there.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
