Rank: Guest
Groups: Guests
Joined: 2/09/2015(UTC)
Posts: 43,977
Was thanked: 5 time(s) in 5 post(s)
|
The old ute has 253blue backed by a m21 4sp with a ford 9 inch diff at the rear. Wish to know if there is a tailshaft that will fit without having to be cut. measured the tube to be approx. 143cm. Can aquire adaptor uni joints for holden shaft to ford diff.
Any assistance would be appreciated
|
|
|
|
|
|
Rank: Veteran
Groups: Moderator, Registered, Veteran
Joined: 1/03/2005(UTC)
Posts: 14,738
Thanks: 1 times
Was thanked: 515 time(s) in 491 post(s)
|
A HQ-HZ TH400 ute/van/wagon/statesman shaft might go close. If it is the right length you'll need a 1-tonner front yoke as the TH400 shaft uses 1.125" unis on the front, same as 1-tonner. You'll also need the adapter uni for Holden V8 1" uni to Ford 9" un |
_______________________________________________________
If we all had the same (good) taste, who would buy all the Fords? |
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
