Fastlane
»
Holden Forums
»
Holden Technical Talk
»
New clutch thrust bearing noise, I'm stumped...
Rank: Member
Groups: Registered
Joined: 9/12/2005(UTC)
Posts: 36
|
Hi all, been a while since I have been on but I'm stumped as to this problem I have. So... HR 186 Toyota 5 spd. ( dellow conversion ) Had to pull out the 186 to have some problems rectified so while this is happening I have a red 202 stocky in. It all fitted no worries but the problem I have now is thrust bearing noise when using the clutch. Easy I thought, must be the "extreme brand" H\D clutch worn ( no shudder) which I noticed had some wear on the fingers when I put it in. Anyway, new clutch in now (a lot lighter on the pedal) and still have bearing noise when depressing the clutch pedal. Only thing I can think of is the hydraulic actuator that pushes the clutch fork ??? I would gladly accept any advice. Steve.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 4/11/2013(UTC)
Posts: 2
|
Had this problem in a LH with a dellow Supra to V8 conversion. Bearing noise, difficult to declutch and wear on the clutch fingers. Went hydraulic with no change. After a lot of money and stuffing around, I went automatic. Never worked it out but I suspect it may have been excessive end float in the crank as it was the only thing I never checked. Good luck with it.
Max
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 4/11/2013(UTC)
Posts: 2
|
Another thing I didn't check, which may not be the problem in your case, was alignment of the bellhousing with the box and/or block. Regards. Max
|
|
|
|
|
|
Fastlane
»
Holden Forums
»
Holden Technical Talk
»
New clutch thrust bearing noise, I'm stumped...
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
