Fastlane
»
Holden Forums
»
Holden Technical Talk
»
Pinion Seal Replacement for Banjo Diff
Rank: Member
Groups: Registered
Joined: 1/09/2014(UTC)
Posts: 1
|
Hi there, I was hoping someone could tell me easy method to remove pinion seal from banjo diff?
I have already dropped drive shaft and removed yoke but I can't seem to be able to remove the seal and I'm worried about damaging something.
Do I have to remove the diff centre or is there an easier method?
Any advice would be appreciated.
Regards,
Phil
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 2/02/2009(UTC) Posts: 564  ![Australia]( "Australia") Location: On a build over WWII airfield. Got the .50 cal cases from my driveway to prove it Thanks: 31 times
Was thanked: 8 time(s) in 8 post(s)
|
Hi Phil, Welcome aboard. It's been a long time since I've done one. We used to just prise 'em out. I wish we'd had seal pullers- just used a screwdriver. We'd use a thin smear of sealer, not silicone on the outer surface of the seal. A smear of diff oil on the lip of the seal too. Here's a youtube video. http://www.youtube.com/watch?v=15zHpz6Zx8c |
Attn camry drivers. The accelerator is the skinny pedal on the right. |
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 10/11/2006(UTC)
Posts: 543
Was thanked: 1 time(s) in 1 post(s)
|
Hi, Phil get a centre punch and mark the front of the nut and the pinion as to do it back up to the same spot as not to change the pre load on the bearing as to tight will collapse the spacer as its ment to do.
pete
|
|
|
|
|
|
Fastlane
»
Holden Forums
»
Holden Technical Talk
»
Pinion Seal Replacement for Banjo Diff
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
