Rank: Member
Groups: Registered
Joined: 23/10/2009(UTC)
Posts: 7
Was thanked: 1 time(s) in 1 post(s)
|
Hi All I am just wondering if anybody would know why there are 2 sizes of spacers for the front cross member mounting?
In HT parts book it lists 7449133 5.15" and 7449134 5.40" a 1/4" difference between the two
I have a set of each and am just wondering which set to fit to my HT Brougham 308 with factory air as when i stripped the car down some 25 years ago i didnt label which set came out of the Brougham
Also does anybody have any suggestions on how to remove the oil filler tube from the timing case so i can replate it
Cheers
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 2/07/2019(UTC) Posts: 26 ![Australia]( "Australia") Location: Ballarat Thanks: 21 times
|
I have never had to attempt that job but if it is anything like the 6 cylinder Holden then I suggest a pair of lock jaw pliers , covering the jaws with a rag . Do not use a lot of pressure and wiggle it and use a hammer on the pliers , tapping upwards until it comes free .
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
