Rank: Member
Groups: Registered
Joined: 16/01/2021(UTC) Posts: 19 ![Australia Australia]() Location: Victotia Thanks: 5 times
|
Good evening.If I remove the tail shaft block up the transmission to hold it up then remove the transmission mount is there any reason or anything to watch out for in removing the extension housing from a Trimatic in a HJ Holden whilst in position? Thank you.
|
|
|
|
Rank: Veteran
Groups: Moderator, Registered, Veteran
Joined: 1/03/2005(UTC) Posts: 14,789
Thanks: 1 times Was thanked: 527 time(s) in 503 post(s)
|
Transmission fluid. I’d suggest you have a new gasket and rear seal on hand and change them whilst the end housing is off. Put some fluid on the new seal before putting the yoke back in. Also best get the rubber seals for the speedo cable end. |
_______________________________________________________ If we all had the same (good) taste, who would buy all the Fords? |
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.