Rank: Member
Groups: Registered
Joined: 29/08/2006(UTC)
Posts: 3
|
hi need to know if there a place i can send my xf flywheel to be repaired with new ring gear as well as mechined and balance as im puting behind a worked 4.1
live nere Wagga Wagga nsw (Tumut)
|
|
|
|
|
|
Rank: Guest
Groups: Guests
Joined: 2/09/2015(UTC)
Posts: 43,977
Was thanked: 5 time(s) in 5 post(s)
|
any place that does clutches should have no problem doing this sort of thing. the balancing will need to be done at the same time as the motor, as the crank rods pistons and flywheel all need to be balanced too
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 29/08/2006(UTC)
Posts: 3
|
yep motor will be balance the one im getting has a full balance, race poistons, lager valves / v/springs, crow cam,crow timing chain,race bearings, race gasket set,
i know flywheel should be on when doing balance but motor was built some time back
|
|
|
|
|
|
Rank: Guest
Groups: Guests
Joined: 2/09/2015(UTC)
Posts: 43,977
Was thanked: 5 time(s) in 5 post(s)
|
|
|
|
|
|
|
Rank: Guest
Groups: Guests
Joined: 2/09/2015(UTC)
Posts: 43,977
Was thanked: 5 time(s) in 5 post(s)
|
You can replace the ring gear yourself - if you have oxy gear. Then all you need to do get it machined.
|
|
|
|
|
|
Rank: Veteran
Groups: Registered, Veteran
Joined: 1/03/2005(UTC)
Posts: 1,991
Was thanked: 2 time(s) in 2 post(s)
|
You don't need oxy or anything fancy. Use a good sharp cold chisel, crack the ringgear off, helps to start with a hacksaw cut,on about 4 parts of the new ring gear polish a small area, put the new ring gear in the oven or use a blow torch or lpg torch, he
|
|
|
|
|
|
Rank: Veteran
Groups: Registered, Veteran
Joined: 1/03/2005(UTC)
Posts: 1,991
Was thanked: 2 time(s) in 2 post(s)
|
Oh as misc said make sure you get it machined if it needs a new ring gear it is sure to be hollowed out, and the new clutch will not work properly.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
