Rank: Member
Groups: Registered
Joined: 20/02/2009(UTC)
Posts: 30
|
Hello, anyone got any advise, ive just put a new 950cfm race carb on my 351 and hooked up a new fuel pump and reg.
Fuel pump is pre-set to 9psi , fuel reg i have adjusted to 4psi and yet it still leaks fuel badly from front and rear power valves just under the bowls.
Could this mean the new power valves are stuffed (2) the psi is still to highor (3) needle and seat stuck?. I havent even started the car yet so this leak is just from turning it on and watching the bowls fill.
Any help would really be appreciated.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 14/01/2008(UTC)
Posts: 48
|
|
|
|
|
|
|
Rank: Veteran
Groups: Moderator, Registered, Veteran
Joined: 5/06/2005(UTC)
Posts: 1,479
Thanks: 1 times
|
Agreed, check the floats then go from there.
"Life, a series of events, woven into a tapestry which becomes our destiny"
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 20/02/2009(UTC)
Posts: 30
|
Hey guys,
yeh carby has glass sight bowls and float levels are sitting just below half way/centre of them.
any other ideas would be much appreciated.
Cheers sixx
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 20/02/2009(UTC)
Posts: 30
|
Should car be running before you set the reg psi or can that be done without engine running and just activating the fuel pump ????
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
