Rank: Member
Groups: Registered
Joined: 18/01/2010(UTC)
Posts: 40
|
Has anyone detailed information on how you fit Scratch plates to the doors of an EH.
Help needed as I brought some recently and don't have the fainest idea how to fit.
|
|
|
|
|
|
Rank: Veteran
Groups: Registered, Veteran
Joined: 3/08/2007(UTC)
Posts: 1,902
|
are there two small dows on the back?
drill two small holes just big enough for these and use an adhesive too
Tuning for Holley carbs in Perth? PM me. |
Old holdens brought on the spot, quick decision, cash paid. |
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 11/08/2008(UTC)
Posts: 916
Thanks: 2 times
|
Some of the older ones have tabs that fit under the door handle, you have to access the back of the handle, loosen the bolts, slide the scratch plate in and do the bolts up again. A bit of double sided trim tape would also help.
I would be very reluctant to drill holes.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 11/02/2005(UTC)
Posts: 607
|
They should have tags that go under the door handle if there are no tags you have a problem check link. https://rsp-secure.com/S...DP1004.jpg&ImageFolder=
|
|
|
|
|
|
Rank: Veteran
Groups: Registered, Veteran
Joined: 22/05/2005(UTC)
Posts: 1,384
|
Loosen door handle, and fit plate with tabs under hadle ends, then tighten handle bolts to clamp the plate. A bit of double sided tape to hold the plate in place makes it a much easier one person job. If it is old or rare - Cut it! http://www.ehlimo.com.au/ |
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
