Rank: Member
Groups: Registered
Joined: 4/10/2008(UTC)
Posts: 77
|
Can anyone give any solutions for removing a roll master crank shaft gear as the previous engine builder has installed it incorrectly.
we have tried using a puller as it has bolt holes either side of the pulley but we hav'nt been able to remove it with the pullers as I'm a bit concerned about the bolts snapping
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 12/05/2006(UTC)
Posts: 501
Thanks: 5 times
Was thanked: 13 time(s) in 11 post(s)
|
put a bit of tension on it with the puller and using an lpg torch add a bit of heat around the crank gear.
With the tension from the puller, as soon as its ready it will "pop" and hopefully come off all the way.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
