Rank: Veteran
Groups: Moderator, Registered, Veteran
Joined: 1/03/2005(UTC)
Posts: 14,738
Thanks: 1 times
Was thanked: 515 time(s) in 491 post(s)
|
Guys
There's an old dude that lives around the corner from my mate's place, north of Tamworth. We help him out from time to time and I go up there regularly so I get him bits he needs from down here (Newcastle). He's currently putting a VS V6 engine (S1 or 2) into a Jackeroo. He's asked me to get him an ECU. I haven't had much V6 experience, only V8. I think the following is correct:
If it's a manual, the Delco 808 will plug into the harness, thus negating the need for a BCM mod. Will it need a new Memcal or will the VN/VP one run it?
If it's an auto he'll need to run the VS ECU and get a BCM mod done. Is this correct?
Any other stuff to be aware of? |
_______________________________________________________
If we all had the same (good) taste, who would buy all the Fords? |
|
|
|
|
|
Rank: Veteran
Groups: Moderator, Registered
Joined: 1/03/2005(UTC)
Posts: 6,067
Thanks: 1 times
Was thanked: 206 time(s) in 187 post(s)
|
Hi Byron.
The problem here is that there is no 'off-the-shelf' memcal that can run a VS V6 (Ecotec) using an 808 Delco. You would have to buy a custom mem-cal.
It probably easier just to use the normal VS V6 sequential ECU & get the mem-cal modified |
If at first you don't succeed, just call it Version 1.0 |
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 29/03/2005(UTC)
Posts: 189
|
Byron, You may alreddy know, but check out www.kalmaker.com.au - they have good info/products on grafting Fuel Inj systems. 666 |
666 |
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
