Rank: Member
Groups: Registered
Joined: 27/02/2010(UTC)
Posts: 48
|
Hello.What do I have to do to put a WB Stato rear into my HZ 1 Tonner.Your help will be greatly appreciated.Thanks,Mick. |
Water makes it's own sauce |
|
|
|
|
|
Rank: Veteran
Groups: Moderator, Registered, Veteran
Joined: 1/03/2005(UTC)
Posts: 14,781
Thanks: 1 times
Was thanked: 526 time(s) in 502 post(s)
|
Remove everything and install it into the 1-tonner housing. Then also modify the caliper mounting brackets to move the calipers as if you don't the handbrake mech fouls the leaf springs. You can weld the tonner mounts onto the sedan housing but there is probably no point as you also have to change the front yoke as the tonner yoke accommodates a bigger uni, hence it all has to be setup again anyway. |
_______________________________________________________
If we all had the same (good) taste, who would buy all the Fords? |
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 3/03/2005(UTC) Posts: 287 ![Australia]( "Australia")
|
I thought the 2.6 ratio is not interchangeableto other housings?
|
|
|
|
|
|
Rank: Veteran
Groups: Moderator, Registered
Joined: 1/03/2005(UTC)
Posts: 6,082
Thanks: 1 times
Was thanked: 210 time(s) in 191 post(s)
|
quote:
Originally posted by crowe
I thought the 2.6 ratio is not interchangeableto other housings?
It will fit as long as you fit its matching hemisphere. Dr Terry |
If at first you don't succeed, just call it Version 1.0 |
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
