Rank: Member
Groups: Registered
Joined: 15/09/2022(UTC) Posts: 73 ![Australia]( "Australia") Location: Perth Thanks: 33 times
|
Hi again :)
Is it possible to replace the timing cover with fully removing the sump ?
TIA
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 3/10/2015(UTC)
Posts: 307
Thanks: 3 times
Was thanked: 34 time(s) in 33 post(s)
|
I presume you meant to say without removing the sump whilst the engine stays in situ.
Look it is possible in theory to loosen/remove sump bolts to allow you to drop the front of the sump enough to take the timing cover off, but the issue is re sealing the sump, both around all edges and in the curved section at the front (difficult to get the rubber gasket to re-seat properly).
So can be done, but fiddly job with likely poor outcome.
|
 1 user thanked Sandaro for this useful post.
|
|
|
|
Rank: Veteran
Groups: Moderator, Registered, Veteran
Joined: 1/03/2005(UTC)
Posts: 14,585
Thanks: 1 times
Was thanked: 483 time(s) in 461 post(s)
|
Awful job. I’d lift the engine and transmission, will mean undoing exhaust and a few other things. Undo the sump and drop it down. Do the timing case cover and put back together. Still awful though and made worse if you have to remove gasket material. If it has a 1 piece rubber sump gasket that helps heaps, but if it is cork and rubber it will also have silastic. I’d remove the engine. |
_______________________________________________________
If we all had the same (good) taste, who would buy all the Fords? |
1 user thanked HK1837 for this useful post.
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
